IAC visits the troll in the dirty D'...
Posted: Sun Jun 05, 2011 5:56 pm
This was Colin's first visit to my new (to me) home in St. Clair Shores.... evidently his internal GPS malfunctioned and he got off the wrong exit in the wrong neighborhood.... but I'll let Colin tell that story.
After the requisite cup of coffee and hour reaquainting session, it was down to business. We took a look at my list, which was a bit of a smorgasbord of various things..... I told Colin "Hey, today is going to be an easy day ... nooo big projects... just a intsy winsy little exhaust stud, and a few other miscellany things.." Needless to say I spoke too soon.... we started about 10:30a and finished about 10:30p.
So what did we get done?
- tapped and drilled one exhaust stud
- JB welded/hammered and prayed over two more exhaust studs (shhhh colin... the JB weld is our little secret, ok?)
- replaced a cv boot
= replaced all of the pushrod tubes and seals
- fixed an extremely annoying oil leak at my drain plug
- adjusted and lubricated the shift linkage
- changed the oil
- and last but not least, determined, that it, in fact did NOT have ANY hydraulic lifters. Which really flummoxed me ... I had swore up and down that I had one. But we pulled out the two lifters from the cylinder which I 'knew' had a hydraulic lifter, and low and behold, both were solids.... go figure.
Oh yeah, gave the bus a new name ' three legged dog' had waay too many syllables, it is now known as simply 'tripod'.
All in all a successful and productive visit.
Cheers,
Mike
After the requisite cup of coffee and hour reaquainting session, it was down to business. We took a look at my list, which was a bit of a smorgasbord of various things..... I told Colin "Hey, today is going to be an easy day ... nooo big projects... just a intsy winsy little exhaust stud, and a few other miscellany things.." Needless to say I spoke too soon.... we started about 10:30a and finished about 10:30p.
So what did we get done?
- tapped and drilled one exhaust stud
- JB welded/hammered and prayed over two more exhaust studs (shhhh colin... the JB weld is our little secret, ok?)
- replaced a cv boot
= replaced all of the pushrod tubes and seals
- fixed an extremely annoying oil leak at my drain plug
- adjusted and lubricated the shift linkage
- changed the oil
- and last but not least, determined, that it, in fact did NOT have ANY hydraulic lifters. Which really flummoxed me ... I had swore up and down that I had one. But we pulled out the two lifters from the cylinder which I 'knew' had a hydraulic lifter, and low and behold, both were solids.... go figure.
Oh yeah, gave the bus a new name ' three legged dog' had waay too many syllables, it is now known as simply 'tripod'.
All in all a successful and productive visit.
Cheers,
Mike