Carb Mounting Stud Loose
- sped372
- IAC Addict!
- Location: Waunakee, WI
- Status: Offline
Carb Mounting Stud Loose
Any experience with a carb bolt (to intake manifold) that doesn't want to snug down because the "knurled" part isn't quite tight enough in the carb? Do I pull it out completely, rough it up a bit, add some jb weld and press it back in? Any other suggestions?
1971 Karmann Ghia - 1600 DP
1984 Westfalia - 1.9 WBX
1984 Westfalia - 1.9 WBX
- Gypsie
- rusty aircooled mekanich
- Location: Treadin' Lightly under the Clear Blue!
- Status: Offline
I had a similar problem with my bug. Dang bolt was sompletely stripped. I found one close to size and did this:
Stripped carb mounting bolt. Filed a bit of the carb to make room for the nut. Probably the culprit for the howling.
even better would be to retap and find a step stud of the right persuasion.
Stripped carb mounting bolt. Filed a bit of the carb to make room for the nut. Probably the culprit for the howling.
even better would be to retap and find a step stud of the right persuasion.
So it all started when I wanted to get better gas mileage....