Replacing slider door seal on early bay
- Elwood
- IAC Addict!
- Location: So Cal
- Status: Offline
Replacing slider door seal on early bay
Any tips on this job and do you have to remove door? That would be very hard for me. Can the rubber be carefully cut and glued down good enough? Thanks
'69 weekender ~ Elwood
- Sluggo
- Wishin' I was Fishin'
- Location: Portland, Or.
- Contact:
- Status: Offline
Re: Replacing slider door seal on early bay
Yes the door does need to be removed. Cut the seal and it will most likely leak. It's really not all that hard to remove or replace. Helps to have a second set of hands though.Elwood wrote:Any tips on this job and do you have to remove door? That would be very hard for me. Can the rubber be carefully cut and glued down good enough? Thanks
1977 Bus with Sunroof - "Lucky '77"
2000cc Type IV w/Dual Weber 36s,
Aircooled.net SVDA w/Compufire,
Redline Weber Fuel Pump,
Holley Regulator,
Half Ass Brush & Roller Rustoleum Paint Job,
Incomplete Custom Interior,
Dual Batteries,
Crunched Slider Door.
------------------------------------------------------