Re: 002 3-RIB FAILURE
Posted: Sat Nov 28, 2015 6:38 pm
Jivermo wrote:Where's the image?
Not relevant to the point that I was making, namely that I am a sheep who followed the directions that Long Enterprises provided. I had a picture of grinding off the tabs. But here is the image further up:
The above image is Chloe's output shaft bearing with what looks like a steel end cap.
Is that a rubber sealed bearing in his image? That would definitely not want those two tabs. They might not be a problem at first, but when end play increases, those tabs would chew . . .