002 3-RIB FAILURE

Moderators: Sluggo, Amskeptic

User avatar
Amskeptic
IAC "Help Desk"
IAC "Help Desk"
Status: Offline

Re: 002 3-RIB FAILURE

Post by Amskeptic » Sat Nov 28, 2015 6:38 pm

Jivermo wrote:Where's the image?

Not relevant to the point that I was making, namely that I am a sheep who followed the directions that Long Enterprises provided. I had a picture of grinding off the tabs. But here is the image further up:

Image


The above image is Chloe's output shaft bearing with what looks like a steel end cap.
Is that a rubber sealed bearing in his image? That would definitely not want those two tabs. They might not be a problem at first, but when end play increases, those tabs would chew . . . :rabbit:


Image
BobD - 78 Bus . . . 112,730 miles
Chloe - 70 bus . . . 217,593 miles
Naranja - 77 Westy . . . 142,970 miles
Pluck - 1973 Squareback . . . . . . 55,600 miles
Alexus - 91 Lexus LS400 . . . 96,675 miles

Post Reply