I'm assembling new HAM 2.0 oval port cylinder heads.
What's the procedure for installing the intake and exhaust studs? There were 4 extra studs in the hardware package andI'm looking at my old ones for guidance.
I was going to put two nuts locked against each other to install them and was wondered of there is a torque value or do they install until they bottom out and snug with a wrench.
I was also going to use Red Hi Temp Loctite on the threads.
Anyt tips or tricks on rocker arms? Links to information?
I was going to use Blue Loctite on those threads.
Cylinder head assembly
- Bleyseng
- IAC Addict!
- Location: Seattle again
- Contact:
- Status: Offline
Thats how I installed them...maybe Len has a different way. Post on HAM's forum on Jake BBS.
Geoff
77 Sage Green Westy- CS 2.0L-160,000 miles
70 Ghia vert, black, stock 1600SP,- 139,000 miles,
76 914 2.1L-Nepal Orange- 160,000+ miles
http://bleysengaway.blogspot.com/
77 Sage Green Westy- CS 2.0L-160,000 miles
70 Ghia vert, black, stock 1600SP,- 139,000 miles,
76 914 2.1L-Nepal Orange- 160,000+ miles
http://bleysengaway.blogspot.com/