remove cylinder head studs or leave them in..
-
- IAC Addict!
- Location: Metro Detroit
- Status: Offline
remove cylinder head studs or leave them in..
I remember reading in the Wilson book that it is best to leave the studs in the case so as not to disturb the threads. Can the engine be cold tanked with the studs in, or do I have to remove? If they have to be removed to cold tank, would it be better to skip the cold tank process and clean by hand?
1976 VW Bus aka tripod
FI ...not leaky, and not so noisy...and she runs awesome!
FI ...not leaky, and not so noisy...and she runs awesome!
hambone wrote: There are those out there with no other aim but to bunch panties. It's like arguing with a pretzel.
- Amskeptic
- IAC "Help Desk"
- Status: Offline
Re: remove cylinder head studs or leave them in..
TrollFromDownBelow wrote: ↑Sun Mar 17, 2019 11:49 amI remember reading in the Wilson book that it is best to leave the studs in the case so as not to disturb the threads. Can the engine be cold tanked with the studs in, or do I have to remove? If they have to be removed to cold tank, would it be better to skip the cold tank process and clean by hand?
The answer may depend on the cold tank associate. You may need to remove studs to fit in the cold tank washer.
Yes it is best to leave stationary studs alone. The solvent will not harm steel.
Colin
BobD - 78 Bus . . . 112,730 miles
Chloe - 70 bus . . . 217,593 miles
Naranja - 77 Westy . . . 142,970 miles
Pluck - 1973 Squareback . . . . . . 55,600 miles
Alexus - 91 Lexus LS400 . . . 96,675 miles
Chloe - 70 bus . . . 217,593 miles
Naranja - 77 Westy . . . 142,970 miles
Pluck - 1973 Squareback . . . . . . 55,600 miles
Alexus - 91 Lexus LS400 . . . 96,675 miles