I need to replace the bottom rear corners on my 73 Double cab. Approximately the last 4-5 inches below the tailights. Are all early Bay corners the same? My '78 is smooth from the light down, the '73 has an indention, for lack of a better word, that goes around the bottom of the corner. It basically follows the contour of the bumper. I just need to know what years are compatible. I may have found a '71 for parts but haven't been there to see it to compare. Any help appreciated!
Thanks!
Panel swaps
- MidWesty
- Getting Hooked!
- Location: Where the grass is blue
- Status: Offline
Panel swaps
"Once in a while you get shown the light, in the strangest of places if you look at it right."
'78 Rivi
'63 Ragtop
'73 Double cab (for sale)
'78 Rivi
'63 Ragtop
'73 Double cab (for sale)
- Amskeptic
- IAC "Help Desk"
- Status: Offline
Re: Panel swaps
'73 and '78 should be compatable as far as mounting to the car. I am unaware of any cosmetic differences between the two.MidWesty wrote: '78 is smooth from the light down, the '73 has an indention, for lack of a better word, that goes around the bottom of the corner.
Colin
BobD - 78 Bus . . . 112,730 miles
Chloe - 70 bus . . . 217,593 miles
Naranja - 77 Westy . . . 142,970 miles
Pluck - 1973 Squareback . . . . . . 55,600 miles
Alexus - 91 Lexus LS400 . . . 96,675 miles
Chloe - 70 bus . . . 217,593 miles
Naranja - 77 Westy . . . 142,970 miles
Pluck - 1973 Squareback . . . . . . 55,600 miles
Alexus - 91 Lexus LS400 . . . 96,675 miles