Is this metal guide sleeve for the throwout bearing http://www.airheadparts.com/viewDetail. ... oduct=7951
an acceptable replacement for the original plastic one on my 77 bus.
Throw out bearing guide sleeve
- RZAR
- Getting Hooked!
- Location: San Diego, CA
- Status: Offline
Throw out bearing guide sleeve
77 Bus. Stock 2.0 FI with Computronix ignitor and coil
- Amskeptic
- IAC "Help Desk"
- Status: Offline
Re: Throw out bearing guide sleeve
Sure. Lubrication (moly grease) between TO bearing and sleeve is mandatory with metal.RZAR wrote:Is this metal guide sleeve for the throwout bearing http://www.airheadparts.com/viewDetail. ... oduct=7951
an acceptable replacement for the original plastic one on my 77 bus.
Colin
BobD - 78 Bus . . . 112,730 miles
Chloe - 70 bus . . . 217,593 miles
Naranja - 77 Westy . . . 142,970 miles
Pluck - 1973 Squareback . . . . . . 55,600 miles
Alexus - 91 Lexus LS400 . . . 96,675 miles
Chloe - 70 bus . . . 217,593 miles
Naranja - 77 Westy . . . 142,970 miles
Pluck - 1973 Squareback . . . . . . 55,600 miles
Alexus - 91 Lexus LS400 . . . 96,675 miles