Ball Joint Going?

Moderators: Sluggo, Amskeptic

User avatar
Amskeptic
IAC "Help Desk"
IAC "Help Desk"
Status: Offline

Post by Amskeptic » Mon May 10, 2010 8:40 am

vwlover77 wrote:That's a relief. When I looked in the hole after drilling, it appeared that everything I had cut was steel. The chips indicated that as well.

I'm wondering if the socket is mild steel instead of plastic? I found this photo on that "other site" that may support that conclusion.

I used 8mm x 5/8" overall length zerks that I picked up at the local NAPA.

I drove the car yesterday and it seems perfectly fine.
IIRC, my new ball joints from Bus Boys had a plastic socket pressed inside the steel bowl at the top as you look at them installed. The 6mm zerks help prevent you from having to thread them in too deep. Or something. I'll let you know what I find when I attack the BobD's originals.
Colin
BobD - 78 Bus . . . 112,660 miles
Chloe - 70 bus . . . 206,845 miles
Naranja - 77 Westy . . . 121,400 miles
Pluck - 1973 Squareback . . . . . . 55,570 miles
Alexus - 91 Lexus LS400 . . . 92,435 miles

Post Reply